Freelander - Fitting Valance Fog Lamps (STC53080)
Fitting Valance Fog Lamps (STC53080)
NOTE: These instructions assume no other auxiliary lights are fitted to the vehicle.
Note: These pictures are intended as a guide, this is a complicated install and should only be performed if you feel competent enough.
 |
Part No. STC53080 - Cost £150.00 ex VAT |
| --> | Parts included in kit. Note differences between LHD and RHD. |
| Tools needed | |
| Firstly lift the bonnet of the Freelander. | |
| Detach the earth lead from the battery. | |
| Detach the positive lead from the battery. | |
| Under each front wing remove the panel that allows access behind inner wing. | |
| Undo the retaining bolt, repeating on other side. | |
| Undo the two screws as indicated, again repeating on other side. | |
| Undo two screws under front of bumper, just in front of the wheel, and repeat for other side. | |
| Remove the two screws in the middle of the front bumper. | |
| Undo three retaining screws under lower grill as indicated. | |
| Undo four screws at the top of the bumper as indicated. | |
| Unhook the bumper at both sides were it joins the wing. | |
| Remove the bumper completely and place on soft surface to prevent being scratched. | |
| Use the 8mm drill to start a hole in the bumper for the foglights as shown, then cut out the section and file smooth. | |
| Attach the 3 fasteners to the foglight surround. | |
| Fit surround into hole in bumper. | |
| Fit two fasteners and 2 screws as shown. | |
| Remove fuse box cover. | |
| Undo two 10mm bolts. | |
| And three 10mm nuts to remove the fusebox.. | |
| Trace cable to bulkhead to find grommet. | |
| Snip off end of grommet as indicated. | |
| Trim excess of wire as shown. | |
| Attach two ends of the engine bay wiring loom to a piece of stiff wire with some insulating tape | |
| And push through grommet | |
| Bring wires into passenger footwell. Note picture shows LHD car, and is incorrect. | |
| Attach plug to wires. |
