Freelander - Fitting Dash Cup Holder STC53044
Fitting Dash Cup Holder STC53044
Tools needed: 1 Phillips head screwdriver
All parts required and fitting instructions are included, along with an extra dash piece for LHD cars.
 |
Dash with rubber mat prior to fitting |
 |
Remove Mat from dash by pulling upwards to expose holes |
 |
Insert the clips into the holes, and press them fully in so they are flush with the top of the plastic. |
 |
Slide rubber up to Binnacle |
 |
Fit cup holder into space on dash, making sure all edges are flush. It may be easier to take out the rubber curve from above fit it to the cup holder and slide the whole lot into place. |
 |
Open cup holder by pressing button on the front |
 |
Insert screws provided into holes that line up with previously inserted clips |
 |
Tighten screws so they are firm, do not overtighten |
 |
Place rubber mats into cup holder locating plugs on bottom of mats into holes in cup holder. |
 |
Press down mats and make sure they are flush |
 |
Fitted and complete. Total fit time 5 minutes.
|
